What should I check first for Whirlpool washer error F0E4?

Check the supply hoses are on the right inlets and not swapped between the hot and cold lines.

What usually causes Whirlpool washer error F0E4?

Hot and cold supply hoses connected to the wrong inlets

F0E4Medium

Whirlpool washer error F0E4

Whirlpool washer error F0E4 means the washer senses the incoming water is too hot during the rinse. Hoses on the wrong inlets is the usual reason.

Also shows as F0 E4

Symptom
F0E4
Free checks
2 checks
Most likely cause
Hot and cold supply hoses connected to the wrong inlets

The 2 free checks

Start at the top. Unplug the machine first.

01
Check the supply hoses are on the right inlets and not swapped between the hot and cold lines.
02
Unplug the washer for 5 minutes, then plug it back in to reset the control.

What causes it

Listed most likely first.

Cause	How often	DIY
Hot and cold supply hoses connected to the wrong inlets	Most common	Yes
The inlet water thermistor (temperature sensor) has failed	Common	Call a pro

If none of that fixed it

If the hoses are on the right inlets and the code persists, the inlet water thermistor is the next suspect. Confirming it means opening the console and measuring about 50,000 ohms at 77°F (25°C) — a technician’s check, not a free one.

Before you check anything

Disconnect the power first. Unplug the machine at the socket, or switch off its circuit at the consumer unit if it is hard-wired. Do this before opening any panel, reaching into a pump filter, or moving the appliance.
Turn off the water before disconnecting a hose, and have a towel and a shallow tray ready — a drain hose holds water even when the drum looks empty.
Gas, mains wiring and sealed refrigeration are for a qualified professional — in many countries that is a legal requirement, not advice. If you smell gas, do not touch any switch: leave, and call your gas emergency number from outside.
Stop if you smell burning, see scorched wiring, or find water near an electrical connection. None of those is a code to look up.

The checks on this page are the manufacturer’s own, rewritten and sourced, and they are reference information rather than a repair instruction for your particular machine. Model, age and installation all change what is safe to do. You are the one standing in front of it — if a step looks wrong for the machine you have, trust that and call a technician.