What should I check first for Whirlpool washer error F7E7?

Unplug the washer for 5 minutes, then plug it back in to reset the control.

What usually causes Whirlpool washer error F7E7?

A fault in the appliance control unit, the user interface, or the wiring between them

F7E7Medium

Whirlpool washer error F7E7

F7E7 indicates a fault in the appliance control unit, the user interface, or their wiring.

Also shows as F7 E7

Symptom
F7E7
Free checks
2 checks
Most likely cause
A fault in the appliance control unit, the user interface, or the wiring between them

The 2 free checks

Start at the top. Unplug the machine first.

01
Unplug the washer for 5 minutes, then plug it back in to reset the control.
02
Turn the spin basket by hand: if it does not spin freely, look for a garment trapped between the outer tub and the basket.

What causes it

Listed most likely first.

Cause	How often	DIY
A fault in the appliance control unit, the user interface, or the wiring between them	Most common	Call a pro
A garment is trapped between the outer tub and the spin basket	Most common	Yes
A worn drive component is adding friction the motor cannot overcome	Common	Call a pro

Differences by model

How the same code behaves on each mechanical generation. Absence from this table is not evidence of sameness — it means no source we hold draws a distinction, not that there is none.
Series	What differs
Front load	On a front loader the only documented remedy is a control reset: unplug the washer for five minutes. Whirlpool publishes no meaning, cause or check for this code on that platform, so everything explained above is drawn from the top loader and may not fit this machine.

If none of that fixed it

Whirlpool offers no further step for this code. If the reset does not clear it, the control unit or user interface needs a service technician — there is no user-serviceable check left.

Before you check anything

Disconnect the power first. Unplug the machine at the socket, or switch off its circuit at the consumer unit if it is hard-wired. Do this before opening any panel, reaching into a pump filter, or moving the appliance.
Turn off the water before disconnecting a hose, and have a towel and a shallow tray ready — a drain hose holds water even when the drum looks empty.
Gas, mains wiring and sealed refrigeration are for a qualified professional — in many countries that is a legal requirement, not advice. If you smell gas, do not touch any switch: leave, and call your gas emergency number from outside.
Stop if you smell burning, see scorched wiring, or find water near an electrical connection. None of those is a code to look up.

The checks on this page are the manufacturer’s own, rewritten and sourced, and they are reference information rather than a repair instruction for your particular machine. Model, age and installation all change what is safe to do. You are the one standing in front of it — if a step looks wrong for the machine you have, trust that and call a technician.