What should I check first for Whirlpool washer error F7E6?

Unplug the washer for 5 minutes, then plug it back in to reset the control.

What usually causes Whirlpool washer error F7E6?

A loose or damaged wiring connection at the drive motor

F7E6High

Whirlpool washer error F7E6

F7E6 is a drive motor fault. Whirlpool lists the code without explaining it; the meaning comes from an independent parts publisher documenting the same top-load platform.

Also shows as F7 E6

Symptom
F7E6
Free checks
2 checks
Then the part
A loose or damaged wiring connection at the drive motor

The 2 free checks

Start at the top. Unplug the machine first.

01
Unplug the washer for 5 minutes, then plug it back in to reset the control.
02
Unplug the washer, then check the wiring connections at the drive motor.

What causes it

Listed most likely first.

Cause	How often	DIY
A loose or damaged wiring connection at the drive motor	Most common	Call a pro
The drive motor has failed	Most common	Call a pro

If none of that fixed it

With no published meaning and no check beyond the reset, there is nothing further to try on this code without a service manual or a technician.

Before you check anything

Disconnect the power first. Unplug the machine at the socket, or switch off its circuit at the consumer unit if it is hard-wired. Do this before opening any panel, reaching into a pump filter, or moving the appliance.
Turn off the water before disconnecting a hose, and have a towel and a shallow tray ready — a drain hose holds water even when the drum looks empty.
Gas, mains wiring and sealed refrigeration are for a qualified professional — in many countries that is a legal requirement, not advice. If you smell gas, do not touch any switch: leave, and call your gas emergency number from outside.
Stop if you smell burning, see scorched wiring, or find water near an electrical connection. None of those is a code to look up.

The checks on this page are the manufacturer’s own, rewritten and sourced, and they are reference information rather than a repair instruction for your particular machine. Model, age and installation all change what is safe to do. You are the one standing in front of it — if a step looks wrong for the machine you have, trust that and call a technician.