What should I check first for Whirlpool dryer error F2E5?

Turn off the dryer's circuit breaker(s) for one minute, then turn them back on.

What usually causes Whirlpool dryer error F2E5?

Control console has an internal software error

F2E5Medium

Whirlpool dryer error F2E5

F2E5 means the dryer's control console or user interface has failed.

Also shows as F2 E5

Symptom
F2E5
Free checks
2 checks
Most likely cause
Control console has an internal software error

The 2 free checks

Start at the top. Unplug the machine first.

01
Turn off the dryer's circuit breaker(s) for one minute, then turn them back on.
02
Start a timed dry cycle and watch the dryer for one minute to see whether F2E5 comes back.

What causes it

Listed most likely first.

Cause	How often	DIY
Control console has an internal software error	Most common	Yes
Control console has a hardware failure	Common	Yes

Before you check anything

Disconnect the power first. Unplug the machine at the socket, or switch off its circuit at the consumer unit if it is hard-wired. Do this before opening any panel, reaching into a pump filter, or moving the appliance.
Turn off the water before disconnecting a hose, and have a towel and a shallow tray ready — a drain hose holds water even when the drum looks empty.
Gas, mains wiring and sealed refrigeration are for a qualified professional — in many countries that is a legal requirement, not advice. If you smell gas, do not touch any switch: leave, and call your gas emergency number from outside.
Stop if you smell burning, see scorched wiring, or find water near an electrical connection. None of those is a code to look up.

The checks on this page are the manufacturer’s own, rewritten and sourced, and they are reference information rather than a repair instruction for your particular machine. Model, age and installation all change what is safe to do. You are the one standing in front of it — if a step looks wrong for the machine you have, trust that and call a technician.