What should I check first for Whirlpool dryer error F2E4?

Restart the dryer: press Power, select a cycle, then press and hold Start/Pause.

What usually causes Whirlpool dryer error F2E4?

Control console has an internal software error

F2E4Medium

Whirlpool dryer error F2E4

F2E4 means the dryer's control console or user interface has failed.

Also shows as F2 E4

Symptom
F2E4
Free checks
2 checks
Most likely cause
Control console has an internal software error

The 2 free checks

Start at the top. Unplug the machine first.

01
Restart the dryer: press Power, select a cycle, then press and hold Start/Pause.
02
If restarting does not clear the code, unplug the dryer.

What causes it

Listed most likely first.

Cause	How often	DIY
Control console has an internal software error	Most common	Yes
Control console has a hardware failure	Common	Yes

Before you check anything

Disconnect the power first. Unplug the machine at the socket, or switch off its circuit at the consumer unit if it is hard-wired. Do this before opening any panel, reaching into a pump filter, or moving the appliance.
Turn off the water before disconnecting a hose, and have a towel and a shallow tray ready — a drain hose holds water even when the drum looks empty.
Gas, mains wiring and sealed refrigeration are for a qualified professional — in many countries that is a legal requirement, not advice. If you smell gas, do not touch any switch: leave, and call your gas emergency number from outside.
Stop if you smell burning, see scorched wiring, or find water near an electrical connection. None of those is a code to look up.

The checks on this page are the manufacturer’s own, rewritten and sourced, and they are reference information rather than a repair instruction for your particular machine. Model, age and installation all change what is safe to do. You are the one standing in front of it — if a step looks wrong for the machine you have, trust that and call a technician.